Driver conflict check

Repeat these steps until you have selected all the check boxes. If you still experience the problem when only one service is selected in the Service list, this means that the selected service causes the problem, and you should go to step If no service causes the problem, go to step 8.

Repeat steps 1 and 3 in this section. Tap or click the Startup tab, and then tap or click to select the upper half of the check boxes in the Startup Item list. Click OK , and then click Restart. If the problem still occurs, repeat steps 8 and 9, but clear the lower half of the checked boxes in the Startup Item list that you originally selected.

If the problem does not occur, repeat steps 8 and 9, and select only the upper half of the remaining check boxes that are cleared in the Startup Item list. If you still experience the problem after only one Startup Item is selected in the Startup Item list, this means that the selected Startup Item causes the problem, and you should go to step If no Startup Item causes this problem, a Microsoft service probably causes the problem. To determine which Microsoft service may be causing the problem, repeat steps 1 through 7 without selecting the Hide all Microsoft services check box in each step.

After you determine the startup item or the service that causes the problem, contact the program manufacturer to determine whether the problem can be resolved.

Or, run the System Configuration utility, and then tap or click to clear the check box for the problem item. Monkey57 Article Author. What is the Make and Model of your device? Is your Important Data Backed-Up? And if anything bad happens you can easily go to Safe Mode before going to main Windows. In any case, you do not want to use Driver Verifier, deactivate it easily by going to below steps. DriverAgent is a third-party tool which can easily tell you that which drivers of your system are good and bad.

And for bad drivers, if any update is available, you can easily update via Driver Agent tool. Apply below easy steps to check inoperative drivers of the system.

You should probably not use the software until Google clears it. Thank you. However, he does read them all. Fortunately, you can use several tools built into Windows to troubleshoot the problems.

Before you begin Before you begin to delve deeply into Windows, you should check your system for an easily resolvable conflict. To do so, boot the machine and go into the CMOS setup. The method of doing this varies between manufacturers, but it usually involves pressing [F2] or [Delete] just before the operating system begins to load.

Once you locate this setting, set it to Off. Now, save your changes and reboot your system. Device Manager At this point, Windows still might not boot correctly. You may have to let Windows redetect the devices in question. The Owner field indicates the device object that owns the range. A value of zero for Owner indicates that the range is not on the bus.

As shown in the example, this operation retrieved the legacy video card that owns the range 3ccf. The same device object is listed near the other ranges it owns 3de-3df and 3ddc. Using the same tracking technique, the range of 3fff is determined to be that used by the serial port. For example, translate the interrupt 3F to an IRQ. First dump the device object, then the devnode:.